Electron & Large

• Category: Laboratuvar Ürünleri
• Measurements:
• Technical Description: DC Output: Voltage in the 0-24 V DC range provides current in the 0-3 A range. The output voltage can be set very precisely with the UP / DOWN switch. When voltage mode is selected from the DC panel, the voltage is displayed in digital display. By pressing the touch button on the side of the digital voltmeter that shows the voltage, the value of the current drawn from the output is visible from the digital display. When the digital display or V Mode is selected, the LEDs are visually easy to see. There is a setting knob to easily adjust the output current. The DC power supply allows the preset current limit from 0 to 3 amps. If the current is greater than the set value, the device automatically disconnects the power supply output and alerts the user by lighting the over current LED. In case of continuous over current from the power supply, the unit automatically cuts off the output voltage. If only one of the UP / DOWN buttons is pressed to restore normal operation, the circuit is energized. It can be easily and safely removed at the outlet ends of the welding with special probes from the + and - Born Terminals that do not touch the conductive parts to the hand touches. The DC power supply has short-circuit and over-current protection. AC outlet; Voltage in the range of 0-24 V DC can supply current in the range of 0-3A. The voltage that is set when the voltage mode is selected from the AC panel can be seen from the digital display. The touch buttons allow the output voltage to be changed by 1V steps. The voltage from the Born Terminals is interrupted during the voltage change. After the voltage settings have been made, the newly connected voltage is applied with a delay of 1-2 seconds to prevent damage to the circuit connected to the output voltage. Symmetrical DC Output; The power supply has Symetrical power output between + 12V and -12V.